2000 Hyundai Sonata "v6 crankshaft" Questions

2005 hyund sonata v6 how to replace crankshaft sensor crankshaft sensor change you have to take off crankshaft pulley.

v6 hyundai sonata? where is the crankshaft sensor located on 1999 hyundai sonata v6 and do you have any tips on replacing it? thanks, jim The CPS for these motors is located in the front of the engine

...crankshaft pulley bolt on a 2004 Hyundai sonata V6 engine. no easy way, yopu will need a air impact 1/2" drive. Unles you can get to the flywheel and jam it, or even take the starter out and jam it. ...

...V6, you also have to remove the front engine mounting bracket from the front of the engine (4 14mm bolts, also a 12mm bolt which bolts the dipstick tube to the side of it) Put crank shaft at TDC (top ...

crankshaft sensor on 2001 sonata V6 Disconnect the battery ground (negative) cable to prevent accidental shorts that could damage the electronic control module. Find the crankshaft position sensor. It

...V6 2000 DOES NOT START NO FIRE CODE PO335 the car does'nt start no fire at the spark plugs the code po 335 defective crankshaft sensor i'm hesitating to change this expensive part The crankshaft ...

v6 engine TENSIONER PULLEY IS SMALL PULLEY NEXT TO CRANKSHAFT.YOU NEED A WRENCH TO ROTATE TENSIONER PULLEY CENTER BOLT TO REMOVE BELT TENSION. follow your belt. there should be a belt routing guide on

v6 no start used to run when cold and then no start I replaced the coil pack,the alt.,and the crankshaft sensor now no spark at all,it's kind of funny I drove the car up on the ramps,changed the crank

...crankshaft position sensor? The 2006 came with a 4 cyl and a 6 cly engine - the crank position sensor is in a different location on each. On the 4 cyl, it's on the back side of the engine block ...

...position sensor? If so, on the four (4) cylinder, it's located behind the timing belt cover at the crankshaft.. if it's the 2.5 V6, it's located behind the LH exhaust manifold on the engine