2000 Hyundai Sonata "crank positioning sensor location" Questions

...security light doing ? Is it flashing when you turn the key on or does it go out. If its not security, it could be a bad crank sensor, a bad PCM, Etc. These things require more observation and ...

...crank sensor is an electronic device used in an internal combustion engine to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to ...

...crank shaft postion sensor is located on a hyundai sonta 2004 v6 ,,,,,,An if you can send a picture on where it is ? thank you ted On a 2.7L it is located above and to the right of the starter. You ...

...crank shaft position sensor get a chilton's repair manual for your car so you can locate the crankshaft position sensor and replace it . it's bad and the car will NOT start or run without a good one ...

...crank position sensor first. How do I change the sensor?? The sensor is located on the left hand rear side of the block (near the bell housing). It is held in place by a 10mm bolt. It's to the right ...

I need help with crankshaft position sensor location diagrand hyundai sonata 2003 on the 2.7l the crank sensor is above the stater motor. On the 2,4 it is behind the timing cover.

...sensor?.. the crank position sensor? If so, on the four (4) cylinder, it's located behind the timing belt cover at the crankshaft.. if it's the 2.5 V6, it's located behind the LH exhaust manifold on ...

...crank sensor. First, I would check for battery voltage at the positive terminals of the coil when the key is on. If no voltage there, try disconnecting the condenser. If there is voltage, then check ...

crank shaft position sensor ? where is the location of fuel shut off value help no inertia switch or fuel switch--fuses or relays ---to test the fuel pump easiest is to spray starter fluid if it fires

2004. Where is the crankshaft position sensor located? Should be under crank shaft pulley.