2006 Hyundai Accent "torque put front axle nut" Questions

Torque Spec Put in new wheel bearings and now Need the torque specs for the front wheel bearing hub/axle Front wheel bearing hub is 147 ft lbs. Axle nut is 170 ft lbs.

pull a little on front axle make its in place. when all done tighten front axle much as you can then when done putting every thing back in place.lower vechicle need torque front axle nut to 217 ft lbs

PUT EVERY THING BACK VISA VERSA. TORQUE HUB BEARING BOLTS TO 70 FT LBS. TORQUE AXLE NUT 284 FT LBS IF YOUR CAR IS 1998 MODEL AND TORQUE AXLE NUT 100 FT LBS FOR THE 1999 TO 2001 MODELS.THE WHEEL HAS TO

...put a punch in the fins of the rotor to keep the assembly from turning while you rmove the nut. You can can do the same thing when you torque the axle nut. 3. Remove the caliper and rotor. 4. Unplug ...

Torque specs for 2002 Chevrolet suburban 1500 4 wheel drive front wheel bearing assembly i usually put lock tight blue on them and tore to 65 ft lbs the nut on the axle i usually tore to 50- 60 ft lbs

...noise left front tire I replace the HUD assembly and put new tires on front Make sure wheel nuts are tight and torqued properly. Inspect hub assembly bolts and axle nut for proper torque as ...

...put everything back together! on a 1999 Honda Accord, the torque for the front axle nut is 181 ft lbs. For the most part, sung it up and then go a bit further. If you are reusing the old axle nut, ...

torque specification rear wheel drive? front bearing wheel nut holding axle on? 115 foot pounds and hammer in or crimp the nut after tightening. ^ like shape into slot of axle this locks the axle. for

...out. Then to put the new one it just put it in, line it up and tap it in, be sure to torque your axle nut to the correct specifications when tightening or you will have a bad wheel bearing in no

...torque specs. Do not put more then 100 psi. It likely depends on the type of four wheel drive system you have. If your system is live axle then it's 162 lb-ft per Ford factory service manual. It's ...