2001 Saab 9-3 "reset 9 check engine" Questions

...check the coil, crankshaft sensor, EVAP or compression?! Maybe it will help! Did u try cleaning your maf sensor? My 9-5 did this and after cleaning the maf it smoothed out and gas mileage climbed ...

9-3 SE 2.0t Conv-Lights came on in traffic-reset with scan tool, and cleaned Mass air flow sensor-lights came back on. Replaced mass air flow sensor-reset lights. Came back on again. Vehicle runs fine

...engine managment light will have to be checked by either purchasing a diagnostic system ( actually could be cheaper than taking to local dealer sometimes check out ebay i got 4 cheap ones) and that ...

...9-3 03 Use this technic for to repair OBD II Depress the odometer "Trip" and "Reset" buttons while turning the key "On." Release the buttons and watch the odometer display for the trouble codes to ...

...9-5 aero has an idling problem. If you keep you foot on the gas, it will drive fine. I have replaced the fuel filter...No fix. I just installed a remanufactured throttle body and the car went into ...

check light on, yet nothing seems to be malfunctioning Is there some way to confirm that there may be a simple solution before I send it to the shop. Autozone will pull diagnostic codes for free. have

...9-5 Turbo I have replaced the fuel pump, the ignition coils, the plugs, the crank sensor, the battery, the gas cap.....and the check engine light hasn't gone off....any suggestions? If I disconnect ...

...check engine light came on our car last night. Vehicle seems to be running fine. We also turned 80000 miles yesterday. Are the two related? could be but have car scanned some auto stores such as auto ...

...P0135 is a fault code for the o2 sensor before the catalytic converter.Replace the o2 sensor and then reset the computer and it should be fine afterwards.The check engine light should stay off

...reset the light. Also if the time for service light is your check engine light a fault code may be stored in the vehicles on board computer. Have the codes pulled to determine if a fault code is ...