2003 Jeep Wrangler "replace high beam light" Questions

high beam indicator light on, no low beams only high beams 2003 jeep wrangler Replace the dimmer switch.  Contact may be fused together if the column stalk switch has no effect.

...no bright beams. Low beams work fine. Lights tested OK for continuity. No voltage to headlamp plug on the high beam side You will need to replace the dimmer switch or repair the plug that goes to

...high beams one light is out . 99 jeep cherokee also my left signal blinking fast but light is on in rear but no light showing in front left light. SOUNDS LIKE YOU HAVE BURNED OUT BULBS, ESP. THE ...

...high beams. I got a new switch from dealer and all is working great now. Here's a link a link I used for switch replacement instructions. ...

high beam will not turn on. I replaced the bulbs with others that work on the otherside and still nothing. I checked wires with tester and both + show voltage when each is switched on. Any suggestions

high beams they will stay on for about 30 sec to 1 minute and then go completely off leaving us in the dark for about 30 sec and then come back on ..but we have to go back to low beam before they will

high beams come on if the switch is held on. sounds like the multifunction switch failure disconnect the switch and jump the light blue/orange wire to the violet/white wire assuming the low beams work

high beam indicater on the insturment cluster doesnt light up either. checked fuses and all looked good. You lose a ground wire, or you need to replace dimmer switch. I had this problem,and the dimmer

...high beam when they are really in low, and when i switch it to low, the highs turn on. any suggestions? This sounds to me like you may have a faulty headlight switch. If the switch is on the steering ...

...replace the turn signal lever. I have the same problem. I figured out a temporary fix in lieu of pulling the relay. With mine (03) the fog lamps will only work when the low beams are on. So I turned ...