1998 Jeep Grand Cherokee "cleaning iac motor" Questions

Ad

...iac stepper motor may be dirty or plugged off when coming back to idle. I would try cleaning it and the throttle body at the same time. Q- tips make it easier to clean and brake kleen makes It easier ...

Ad

Question about Jeep Grand Cherokee

3 Answers

IAC can be cleaned; however, if this cleaning procedure is not properly done, the IAC can become damaged. This sensor is also sometimes called the "Cold Start" sensor. A new IAC will cost $50-$100. 2)

Ad

Question about Jeep Grand Cherokee

1 Answer

...cleaning the valve and passages as well as the throttle body with carb cleaner. Check the operation of the valve by hooking up the connector and turning on the key (do not start the car) while it is ...

Question about Jeep Grand Cherokee

1 Answer

...rid of your problem. I would start with the IAC motor first. The IAC motor is located on or near the throttle body. The EGR is on the intake and will have a flex tube running to the exhaust

Question about Jeep Grand Cherokee

1 Answer

...IAC motor circuits for 2.75 seconds with the IAC motor active. id fix the 351, cop coil , its probably bad, or bad connections to it. then clean the iSC, then reset all codes, with a scan tool drive ...

Question about Jeep Grand Cherokee

2 Answers

IAC motor or the powertrain control module? well usually when i scan out that code usually replace ICM idle sensor motor! you should have a hard time idle or really rough one for this to go good place

Question about Jeep Grand Cherokee

1 Answer

...You have a vacuum leak or your IAC moter is dirty or bad You idle motor is on the side of the throttle body and controls idle you code is the idle is to high or to low. Pull off and clean or ...

...plugged into it. It wouldn't hurt to remove the IAC and try cleaning it before you replace it. Sometimes they just get really gummed up. Another thing that can cause this symptom is a vacuum

Question about Jeep Grand Cherokee

1 Answer

...motor ( IAC ) it sticking , Its located on throttle body. When you remove it you find the plunge covered with crankcase vent carbon and passage clogged with it too. The fix is to brush off the plunge ...

...Vehilce show no codes. Vehicle runs great other wise. Any ideas? Please help have you checked the IAC, idle air control,or cleaned the throttle body and plate. check motor mounts and tranny ...

Not finding what you are looking for?
1998 Jeep Grand Cherokee Logo

1,953 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...