2005 Chrysler Pacifica "engine removal" Questions

...ENGINE/RADIATOR FAN - REMOVAL). Remove the wiring harness clip from front mount. Remove the coolant line clamp bolt (COOLANT LINE BRACKET). Remove the upper nut from the front mount (FRONT RUBBER ...

...Hi Gerti , It is very easy , First lift the vehicle through jack or hydraulic lift and drain the engine oil in a pan and arrange a new engine oil filter and oil as it is better to replace( u can ...

...Remove the cover over the radiator then the coolant line bracket remove the bolt from the front engine mount support engine remove bolt on trans and anything else that would be in the way remove ...

where are the spark plugs on the 3.5???? Pull the cover of the top of the engine. Remove the screws that hold the intake manifold to engine. Remove bolts holding anything to manifold. Lit it up toward

oil light turning on when I turn on vehicle for a couple of minutes n makes a noise in engine n then light goes off and noise dissapears whst Sounds like the engine is just about gone. The noise is ...

...Removal & Installation To Remove: Before servicing the vehicle, refer to the precautions in the beginning of this section. Drain cooling system. NOTE: The water pump is driven by the timing belt. ...

...are located and inserted into each cylinder location, just under the respective ignition coil. This engine is designed for a Coil on Plug setup. The ignition coils are attached to each plug in the ...

...Engine Fan Radiator Thermostat Removal & Installation Water Pump HOME  REPAIR HELP  2004 CHRYSLER TRUCK PACIFICA 2WD 3.5L SFI SOHC 6CYL REPAIR GUIDE ENGINE ...

...what your car looks like because we don't have then in Australia. First you have to separate the engine from transmission, rear wheel drive just remove tailshaft and gearbox, in front wheel drive ...

...to find out where the spark plugs are Trying to find out where the spark plugs are located on the engine I have looked everywhere, help... You need to remove the cover and you'll see the coil packs