...remove the cover and remove the screw below it. Next pry the door panel from the bottom untill it "pops" out and grab it and pop the rest of the panel out, lift the panel up off of the window
...remove/disconnect the door latch rod and possibly the locking mechanism to reach the outside 'skin' of the door and access to the inside of the handle. From there it should be pretty straight forward ...
Question about Subaru Impreza
...remove the door panel,bring glass down until you are able to se bolts that hold it to reulator,remove them and remove glass now remove 4 bolts holding regulator unit in and rtermove regulator and put ...
...door panel was removed to install new speakers and we are not sure if it was put back together properly and whether or not all connections were hooked up properly Speaker wires could be shorting out ...
...remove the door panel from the inside and could get all of the cables and wires disconnected from the door/ panel. I could only pry back about half of the panel cause of the glove box in the way. I ...
remove the door panel, see if the window regulator bolts fell out. they are usually in between the plastic door covering and the door or inside the door on the bottom. they are four bolts that a 10 mm
...remove driver side kick panel/lower A pillar trim connect locking registration wires together(two white connectors,black wire and black and blue wire)press and hold central locking switch on drivers ...
remove them and put a meter on them. You can cross the wires to see if the window will go up or down. If you can do it by crossing the wires then the switch is bad. Usually, when no windows work, it's
...door. Pull the fuse for the blower and inspect it. In most cases, if the fuse is blown, you can tell because the metal strip inside is broken. You can also test the fuse with an ohmmeter without ...
369 questions posted
Usually answered in minutes!
182 Questions
128 Questions
134 Questions
125 Questions
115 Questions