Question about Mercury Mountaineer
...Spark plug wires just pull off and press back on. Make sure you grasp the wires by the rubber boot only. If you pull the wires by the wires, instead of using the boot, you can break the wires. Remove ...
Question about Mercury Mountaineer
...plug. the coil should have one 8mm bolt holding it on the lower intake manifold. remove the coild to get to the spark plugs. look by the fuel injectors, coil should be just next to it or very close. ...
...spark plug lines ... that shaking could be one plug not firing causing a out of rythem engine vibrations if they are all connected then try disconnecting plug wire hold plug wire near metal near plug ...
recently replaced plugs and wires, but when i spray a little water on wires I see sparks jumping. bad wires? yes, you should have at least 9 mm thick insulation on the wires. motorcraft or other name ...
help on the mounting of the new plug wires to keep them away from the heat of the manifold! You need to replace the factory spark plug wire loom holders, see your local Ford dealer for the proper ones
...spark plug socket they work nicer) and get some extensions and a ratchet and some swivels. I like to use 3/8 size tools. Once in a while a 1/2 tools may be nice if a plug is not coming out. Next soak ...
...spark plug socket, swivel, extension and ratchet. Some engine installations may require additional extensions or swivels to get the back plugs removed. It normally takes just an 1/8 turn to break the ...
i need to change the spark plugs and wires To change spark plugs you will need a 5/8 socket and extensions and a ratchet, you will go above the front tires using the socket and extensions to change ...
...spark plug if it does not look fouled start the vehicle with the plug still connected and look at the ground electrode for any spark it should be a white arc which indicates a high intensity spark if ...
385 questions posted
Usually answered in minutes!
658 Questions
555 Questions
524 Questions
377 Questions
323 Questions