1995 Mercury Villager "bank 1 sensor" Questions

...Bank 1 Sensor 2) PO325 is a Knock Sensor 1 Ckt Malf in Bank 1 or Sensor 1 You're problem is in Bank One, more than likely an O2 sensor...I'd go to AutoZone or your parts store and ask for a ...

...Bank 1 Sensor 2Possible causes- Rear Heated Oxygen Sensor Bank 1 harness is open or shorted - Rear Heated Oxygen Sensor Bank 1 circuit poor electrical connection - Faulty Rear Heated Oxygen Sensor ...

...Bank 1) What does that mean? Basically this means that an oxygen sensor in bank 1 detected a rich condition (too little oxygen in the exhaust). On V6/V8/V10 engines, Bank 1 is the side of the engine ...

...connection it is a 2000 mercury villager it is bank 1 sensor 2 this is the rear sensor. The connector is near the oil filter, passenger side. http://groups.yahoo.com/group/villagerquest/ go here ...

...experience what is the cause the codes started with 11 i presume they refer to bank 1 &2 oxygen sensor ,follow this link for in depth advice etc Oxygen Sensor Codes Avoiding The Common ...

...bank 1 oxsensor 1 i change new but light on sam wrong That is because an O2 Sensor Code or any DTC Code doesn't tell you what to replace It doesn't work that way. You use the code, to get to the ...

...but I am still pulling code 55 on a 95 villager can't figure out what going on need help The Code shows Bank 1 Sensor 3 for the O2 system. That the wire going to that part is broken or

...bank 1 what does this mean and how do I fix it? Had the same code with an Expedition. Try cleaning the MAF sensor with some carb cleaner. Here is more info on the code: ...

bank 1 senor 1. after driving little bit same code came back again. then I replaced thermostat (the metar was always low, now it is ok) But still my check engine light on with code PO135. I use Actron

...bank 1 sensor 2) Sounds like you may have 4 sensors on this vehicle. Get the Haynes repair manual on this vehicle so you know where this sensor is actually located. When you get this manual pick up ...