1997 Lexus ES 300 "vent valve car" Questions

Question about Lexus ES 300

How many EVAP Vapor Pressure Sensor(s) are there on a 1997 Lexus ES300?

...Is there another one else where on the vehicle? 2, The purge valve and the vent valve. The one by the canister is the vent valve. The purge valve is close/mounted to the engine. Follow the

Question about Lexus ES 300

1 Answer

I have a es300 with a 0446 code and I am told I need a vacuum switch. Where is the vaccum switch located? I have ordered the part (without the canister) and I hope I can figure out which switch it i

...vent control valve is located on the EVAP canister and is used to seal the canister vent.This solenoid valve responds to signals from the Engine Control Module (ECM). When the ECM sends an ON signal, ...

Question about Lexus ES 300

1 Answer

Obd 2 code p0446 on a 1996 lexus es300

...Vent valve control circuitBlockage of vent valveBad PCMWith a P0446 OBD-II trouble code, here are some things to try:Replace Vent valveRepair open, short, or resistance problem in control ...

Question about Lexus ES 300

1 Answer

WHAT CAN I DO TO SOLVE PROBLEM CODE PO446.

WHAT CAN I DO TO SOLVE PROBLEM CODE PO446. P0446 = Evaporative Emission Control System Vent Control Circuit failure - the circuits that control the charcoal cannister are faulty or they are detecting ...

Question about Lexus ES 300

1 Answer

Did not pass smog need help with error codes p0441,p0442,p0446

...vent valve not closing properly. Once the nature of the leak is diagnosed it is matter of fixing it and it should not be an expensive or time consuming job. Take the car to other mechanics and get ...

Question about Lexus ES 300

1 Answer

P1410, P0441 & P0773 codes in '97 Toyota Camry

...Vent Solenoid Valve Control System Ok, above are the codes listed on your description and there respective definitions. the P0441 and the P0446, basically run parallel and they mean the same thing. ...

Question about Lexus ES 300

3 Answers

Check Engine P0446 & p0773 Codes

...vent control valve circuit. Probable cause: 1) Open or short circuit condition 2) Poor electrical connection 3) Faulty vent control solenoid P0773 Definition: BBShift solenoid "E" electrical ...

Question about BMW Cars & Trucks

1 Answer

Where is the fuel tank vent valve located on a BMW X5 e70?

vent valve located on a BMW X5 e70? I need the location of the vent valve, not the purge valve In most cars, the EVAP vent valve is located underneath the vehicle, close to or at the charcoal canister

Question about Lexus ES 300

2 Answers

What does code p0446 mean on a 2001 Buick Centry?

...vent valve ON. This allows a vacuum to be applied to the EVAP system. Once a calibrated vacuum level has been reached, the control module commands the EVAP canisterpurge valve OFF and the EVAP ...

Question about Cars & Trucks

1 Answer

When the gas pedal is pressed a throbbing noise comes directly from the vent valve and woun't stop unless the car is shut off. What does this mean? Do i need to replace the vent valve or is there anot

...vent valve and woun't stop unless the car is shut off. What does this mean? Do i need to replace the vent valve or is there another issue casuing this problem? Seems to stop throbbing when i stuff a ...