2004 Jeep Grand Cherokee "replace throttle body 2001 dodge" Questions

...from the backside of throttle body) to check for carbon bild up and possible faulty valve.Once removed if the little pintle is sticking out more than 1 in. then replace valve. Hope this will

...Replace all intake manifold gaskets and plenum gasket. If this does not confirm intake leak , have the Throttle Body cleaned manually by a professional, or yourself using specifically" Throttle Body ...

...sensor - will make it upshift and downshift erratically also. Around $24.00, 5 mins to pull and replace--bottom electrical connector on your throttle body-drivers side-two torx screws hold it ...

...throttle body - be sure and place a cover, rag or something to prevent anything from falling into the engine. Rear plugs can then be accessed fairly easy. While intake is off, clean it by introducing ...

...replace the throttle pedal position on 2001 Durango How do I replace the throttle pedal position sensor A circuit on 2001 Durango TPS is located on the side of the thottle body, and is secured by ...

& spray well inside port it comes out of. I believe on that engine, it's at front of throttle body, under TP sensor. If it cures the problem, then starts doing it again before too long, replace it

...Check the fuel pressure,you need special equipment for this. If all else fails,you probably need a t.p.s.(throttle position sensor). Might need to replace the entire throttle body to get the

replace the spark plugs, wires, coil pack and have checked all the fuses. I also look at the timing belt and it seem to be ok, lined up right. I also have checked all the fuses and they are ok. Please

throttle body, replace air andf fuel filters, check drive belt. Hello there: Normall this involves the following (1). spark plugs and sparkplug wires. (2) distributer cap and distributer if needed (3)

...throttle body when it was running ok and warm it did want to rev up briefly then corrected its self, the cables for the throttle do have a little play but they are not bound up. I have been using a ...