1998 Honda Prelude "car cutting lost power crank" Questions

car started but then lost power, backfires,and doesn't want to idle or run very well. Need a clear question and better info. However, based on the little that was posted... Code P1361 is ignition coil

...lost power. wouldnt crank. Had it fixed again.. the computer said a cam shaft censor was bad. so we changed it. also changed spark plug cables. Still doesnt work. It turned over for a few seconds but ...

...cutting off like it runs out of gas then give it a second an it cranks bk up no car told ,maker ,model, year. cuts out as is total engine stall ,dead? or power from engine is lost for a second and ...

...driving. for a period of about 2 hrs the car will not start. then it starts first time power steering is lost and is dangerous whilst driving in traffic Hi it could be you crank senser that is ...

...lost power and cut off i started it back up but it cut off again. now its just turning over but wont start As with any no start issue, you will need to figure out if it is caused by no spark or no ...

...Honda crv acted like it lost all power and cut off kinda like fuel pump but when I tried cranking it bk it sounded like it jumped time. Just put new one on it. What could it be? May be fuel

Car lost power while driving then cut off and will not restart was told its a broken crank shaft has no compression but belt turns and cams turn Broken cranckshaft will have a knocking noise, did you ...

car cranks but dont start? just a clue here.? looked at alldata.com and there are no cut out.s. no inertial, rollover or oil pressure fuel cuts. the PCM controls 1 fuel pump relay that powers the pump

...Lost some power I cut car off restarted now engine lite stays on car running fine now Also I justed cranked now engine lites off driving fine what's wrong ray365m most cars have a check engine light ...

...lost power up until it cut out completely. Iff you crank it it sarts and cuts of immediately. We tried to see for any active codes on engine controle unit but our diagnostic tool does not communicate ...