obd2 plug. check your fuses. Scanner datalink is a powered connection, usually fed by the same fuse as the cigarette lighter...cell phone chargers frequently blow the fuse, disabling scanning till its
...plug Check your fuses...the fuse for the OBII is probaly blowed...Or see if the scanner works in another car, to make sure the internal battery on the scanner is good.. the obd2 uses the cigar fuse ...
...OBD2 port isn't working with my Snap on Scanner MT2500 Yet when I get it smoged their scanner works. Any ideas? I did try another type of scanner and had the same problem as the Snap On. CHECK YOUR ...
obd11 scanner not connecting cant find fuse The cigarette lighter fuse also powers the scanner OBD2 plug.
Question about Cars & Trucks
Why my obd2 port isn't reading computer with scanner plugged in? Car has check engine light on. On board diagnostics 2 scanner won't power up. Check ECU fuse.
power like it's not getting enough gas. Check engine light is blinking. No odd smells or sounds You have a bad coil pack, they usually crack from age and heat. It's best to replace them all. Check for
...obd2 scanner is there's something wrong in the ground circuit in your vehicle. one has to painstakingly trace those grounds to make sure they're clean/ not corroded... then go from there Check the ...
...power and grounds at the OBD2 connector and they are ok. But the data link wire "purple wire" is also showing to be ground. Does anyone have any ideas what could be causing these problems and if the ...
...gone out and check the back of the obd plug to make sure no one pulled the diag wire from the plug assembly. Check for power and ground at the data-port, check all fuses for OBD2 &
...plug in my hand held OBD2 scanner, I get a no link message. Is the pcm bad or can there be a wiring problem? 2000 contour have power to relay. did more testing on power to pcm,tested pins on pcm ...
1,584 questions posted
Usually answered in minutes!
1,041 Questions
758 Questions
811 Questions
722 Questions
687 Questions