1994 Honda Accord "cause pressure washer run" Questions

...pressure on windshield washer fluid sprayer. Its just plugged up, probably right at the nozzle it's a pretty tiny hole. To clear it out you need to find a small diameter wire that will fit inside the ...

...cause for an open or shorted circuit.  12. If all wiring checks out, test the fuel pressure, as outlined later in this section.Fuel Pump PressureThe fuel pressure should be checked at the fuel ...

...cause improper adjustment and possible damage. Tighten the lockbolt installed earlier to lock the timing belt adjuster arm. Remove the crank pulley. On Prelude VTEC models: Hold the auto-tensioner ...

...cause improper adjustment and possible damage. On Prelude VTEC models: Hold the auto-tensioner with the maintenance bolt facing up. Loosen and remove the bolt. Handle the tensioner carefully so the ...

washer has such low pressure that it doesn't reach the windshield. We have checked the fuses, blown air through all the hoses and nozzles and the pump is running, so what else could be causing low

...the crush washer too much. The crush washer is design to distort to cause an air-tight seal and prevent leaking. Leaking oil would reduce pressure and, in turn, cause check engine light to come ...

pressure washer can I use this. I dont want to cause more problems?? hello there yes you can wash the engine but keep away from the pressure washers. the car should be running when you are washing it,

...pressure atomized the fuel. If you don't this certain injector pattern it can cause excessive fuel consumption and ruff idling or running. I wish you luck Buddy. My Aussie buddies in Vietnam keep ...

pressure cleaning an engine can sometimes cause water and soap to push down beside the spark plugs in a spark ignition engine. Sometimes this will cause the engine to run a little rough until the heat

...cause of the leak and then take the appropriate corrective action. If the water pump seal is worn or damaged, you will need to replace the seal. If the water pump bolts are loose, you will need to ...