...and cant reset it . it blinks 2 times slow and then 1 fast short one , and then repeats itself check engine light codes. if its vtec. there is your problem. ...
...VTEC, THE OTHER PROBLEM IS IT IDLES AT 1600-2000 RPM HOW DO I FIX THIS OR FIND A PROPER DIAGRAM? Wiring faulty, sensor not connected or mismatch, the ECU will not operate normally until it get all ...
...code P1259--vtec. When drive, the engine can not run more then 3500 rpm. The car will slow down and accelerate at 3500 rpm. Checked EGR valve, it is clear. Changed spark plug. not help. Can anyone ...
...code. It is not a Vtec engine... help. I just got the oil changed and the light is still on. However they put 10w30 in.. should I get it changed to 5W30? The P1259 : is problem in the VTEC Oil ...
...LOCK UP SOLENOID AND CONNECT AN ADAPTER BETWEEN THE SWITCH AND THE SOLENOID. BUT I CANT SAY ITS YOUR VTEC SYSTEM UNTIL YOU CODE SCAN CAR.OIL PRESSURE SHOULD BE 50 PSI @ 3000 RPM OR 85 PSI @3000
...code and it's P2649. I've replaced the VTEC solenoid and the VTEC assembly, but that did not fix the problem. Please help. Did you clear the code after replacing the assembly? did the assembly have ...
...code related to VTEC related Honda engines. I am sending you a little reading on that error code.. Best of Luck.. The Check Engine Light (CEL) is on. Trouble code P1259. Tests/Procedures: 1. Locate ...
code for vtec malfunction usually cause by a bad vtec solenoid, vtec pressure sensor, low oil level, bad connection. Was oil change done? May want to check the oil level. P1166 is a code for a primary
...wiring from sensor to ECM checked good. This is on 2.3liter VTEC engine what do I check now. Pulled codes by jumping OCD 2 plug only get code 8 problem could be with the vtec. not varying timing
code 1259 which says 1. open or short circuit cond. 2. Vtec solenoid valve fault 3. vtec pressure switch fault 4. blocked oil passage Don't know which one it could be without going to shop. Anyone had
129 questions posted
Usually answered in minutes!
