2004 Volvo S40 "remove lock cylinder remote trunk" Questions

...remove the lower holding bolts slide up off the top lock setup see if theres enough room to work from there to pop the trunk open with a flash light and a screwdriver if not your going to have to pop ...

...I gain access to the trunk lock without destroying the lock cylinder and buying a new one? i'm not 100% sure with that vehicle, but you might be able to remove the back seat to gain access to the ...

...remove the plastic casing that hugs the back of the key lock cylinder but do not want to break it off, is there a way this snaps off or is there a turn and twist or are there hidden clips. its kinda ...

...lock cylinders are original. Usually they will require proof of ownership before doing so. Older style cars did not always have remote trunk release. Call dealer ask if remote trunk release equipped. ...

...it? mark check the alignment adjust if necessary ,,if lock not turning and key turns in cylinder replace cylinder --if cylinder turns and latch not moving check actuator rods are present and ...

Remove the cover to expose the lock cylinder then use your key. Here is the link to the owner's manual on the process of unlocking the trunk with a dead battery or dead remote. The key lock is under a

...lock out then remove the nut. and then directly below lock is another screw remove that and pull the clip the lock cylinder shall come out and you can now go to any auto parts store of your choosing ...

...remove the door lock cylinder by loosening the t20 torx screw near the door handle until the lock cylinder slides out(DO NOT LOOSEN MORE THAN NECESSARY TO GET THE LOCK CYLINDER OUT), then use a ...

...There should be a key slot in the trunk emblem, or the emblem will spin to reveal it. If the key just spins it needs a new door lock cylinder. You can see my previous solutions for how to remove

...lock cylinder. Remove the E-clip. Disconnect the latch lever. NOTE: The door disarm switch can be installed in more than one position. Before removing the switch from the cylinder it may be necessary ...