Question about Volvo S70
...about 30 degrees off of tdc. There are no marks for the cams to line them up. You need the jig that holds the cams in place. I have 35 yrs working on Volvos as a professional tech. YOU CANNOT do this ...
...hold the plastic head light frame. Then remove the screws that hold the metal frame that holds the head light in place. Make sure that you DO NOT move the head light adjusting screws. Hope this
Question about Volvo S70
...hold. The head gasket, does not hold some pressure, it has to hold thousands of explosions per minute for years and years. Let a specialist check the head and engine need flattening. Sorry English is ...
...head back. Fit 2 ten inch tie straps so they hold the vacuum harness (5 hose) tight to the control head. You can remove 2 torx bolts to lift bottom cover if necessary. Vacuum harness is $20 ...
I need to know how many quarts of oil my 03 suzuki vitara will hold? the single over head motor holds 4.4 qts. and the dual over head cam motor holds 5.5 . let me know if you have any more question.
Question about Volvo S70
...head lights went out,,I can hold back on the switch and my brights work,,but I pulled a fuse and my head lights work,,but my park lights will not work Sounds like you lost your ground to both head ...
...hold the upward tension with the bungee cord so the timing belt doesn't jump a tooth on the lower pulleys 22. Remove the head bolts and lift the head off the engine block . (I suggest having an ...
Question about Volvo S70
How many foot pounds of torque should I use to tighten the bolts that holds the crankshaft and the bolts of the pistonshaft on to the crankshaft????? bolts that holds the crankshaft and bolts that ...
Question about Mazda Cars & Trucks
...on my 2008 mazda bt50 3.0lt un model after removing all the head studs there seems to be something holding the head down on the inlet manifold side i have used mirror but cannot see what is holding ...
Question about Volvo S70
89 4 cyl dont hold water comes out around doughnut gasket and exhust pipe dont hold water comes out around doughnut gasket and exhust blown head gasket or cracked head so sorry
459 questions posted
Usually answered in minutes!
664 Questions
232 Questions