...replace the filter and re-use the gasket if its the reusable factory gasket ( has hard inserts around each bolt hole) then re-fill the transmission through the filler tube on the right side of the ...
...Replace power steering pressure hose O-ring. Install the power steering pressure hose to the power steering pump fitting. Tighten the tube nut with a tube nut wrench rather than with an open-end ...
mercon3 vs mercon 5 Mercon 5 replaced the older three, it has better friction and wear characteristics, this translates to longer transmission life
...MERCON V ALSO. YOU'RE NOT GETTING ASSIST MAYBE RACK IS BAD,IF IT LEAKS SEALS MAY BE BAD ALSO LETTING IN AIR. LOOK AT YOUR LINES,MAKE SURE NO LEAKS OR BINDING. DID YOU ALSO REPLACE TEFLON O-RING AT ...
...miles replaced filter and gasket, replaced fluid. same problem. today had fluid flushed. asked for mercon 5 mechanic put dextran and put an additive, claimed that brings it up to standards of mercon ...
...replace the O rings? I dove it home (about 6 miles) so I know it's already mixed in. You need to remove the fuel injector fuses so the motor will not start Then remove the power steering ...
...Ford dealer close by to where you live, ask them for the right fluid, and you can't go wrong then. Mercon V { which has replaced Mercon trans fluid is
...REPLACE FILTER AND CHANGE FLUID Discribe sluggish. Changing the fluid has nothing to do with shift stratagy or correct trans operation. Change the filter every time you do the fluid,unless your just ...
...approximately 5 minutes. Shut engine off, release vacuum and remove vacuum source. Add Motorcraft MERCON Multi-Purpose (ATF) Transmission Fluid if necessary and install dipstick or reservoir cap. ...
...is cold right now and snowy so i want to wait until it warmer so i want to keep it full until then. Mercon V is the correct replacement fluid. Use MERCON®- V Automatic Transmission Fluid. That should ...
593 questions posted
Usually answered in minutes!
661 Questions
611 Questions
534 Questions
488 Questions
496 Questions