1991 Jeep Wrangler "fuel pump ground wire" Questions

fuel pump. what else should i look for?anyone have this problem? need help The fuel pump ground wire is loose. If you have a loose parking brake pedal or recently had it worked on, check the black and

...fuel pump and ingecters to work on my 93 jeepwrangler with 4.0 i think it is a wiring problom Check the red/white wire at the fuel pump relay for 12v check the white/yellow wire for 12 v check the ...

...fuel pump and if good, trace wiring to the front, at ignition. many pressure regulators control the operation of the fuel pump when pressure is reached the pump switches off so check for wires and ...

...fuel pump and now the coil is getting no fire when i hook the battery back up My 1991 Wrangler would alternate between no spark and no fuel. After replacing the crank sensor, the coil, and the fuel ...

...fuel pump orange wire .6 volt brown 7.6 volts is it fuel pump or sensor check your fuel pump relay and your ignition switch those numbers you gave for voltage are not right, please recheck that you ...

...fuel pump. I have looked for a fuse but cannot find one. on a 1995 it is beside battery but nothing on a 1990 ( Where is it located) Or is there something else wrong. I have located a connector next ...

...fuel pump after i got the problem, and it still keeps doin it. would run for a min or two then fuse would blow then replace and same thing now its not tryin to start Measure resistance between the ...

...fuel pump to kick on ( which is then followed by the fast 'tick tick tick' of the fuel pump relay ), once cycled, I can then attempt to start. On a nice, warm day of say 65, it immediately starts the ...

...i have no spark and no fuel. the fuel pump kicks on but the injector dosent pulse fuel out, just replaced the crank sensor and still nothing. check for a bad ground wire or disconnected ground ...

...fuel pump I am replacing the fuel pump on my wrangler. have the tank and pump down, disassembled and ready to wire the pump in. i have assumed the two wires on top of the pump go to the corresponding ...