1991 Jeep Wrangler "fix cylinder compression" Questions

...cylinder wear 2.5 chrysler? Apart for rebuilding Q you mean compression is low, right using tools? and with added oil and not what is it. ? doing the compression test. oil last , and pressure rise is ...

...it possible they got the timing for the crank and camshaft all wrong?  Take it back to them and demand they fix it, if it truly has no compression.  It will never start without

...cylinder. IF you do find a stuck injector you can try the redneck fix. Put a long socket extension on the injector and tap lightly with a hammer while the engine is running. TAP LIGHTLY!!! ITS ONLY ...

...cylinder 2, however I replaced the injector and it didn't seem to fix anything. It has a really rough idle, and struggles under a load while driving. I can mash the gas and it will go, but it dies as ...

...fix the problem ASAP. If you say it 'won't stay running' it might be the catalytic converter has already been destroyed (i.e. clogged) Start with a compression test. Running through water can cause ...

...starter and no spark. took off dist. cap and sprayed in WD40 and still nothing!? You have likely fixed this by now but if not, you will have to use some dry rags and dry off everything!!!! Use ...

...compression all the fuel and spark in the world can not run dead cylinders. ever. 2: then spark, check that all spark plug tips are clean and the spark is strong. then check timing, if any thing here ...

fix the issue, it is a tumbler problem. Same problem on a '98 Wrangler. Been that way for some time. Wiggling the key usually works, but takes a LOT of wiggling sometimes. Very Frustrating. Everyone I

...compression cylinder Time for a new car, unless you want to spend the big bucks to repair your engine. Low compression, below 100 psi, means the cylinder will not fire, will miss, have low power. The ...

...fix it without replacing entire motor You *most likely* have bad valves in those two cylinders. If adding an ounce of motor oil to those cylinders and then compression check again and still no ...