1991 Jeep Wrangler "adjust tensioner new serpentine belt" Questions

...new belt is not stretched at all. Bring tension back up with the tensioner screw. Use your thumb to press on the belt on one of the long spans. Under moderate pressure it should move about 1/4 inch. ...

...TENSIONER Loosen rear mounting bolts of idler pulley or power steering pump (if equipped). Loosen power steering pivot bolt and lock nut (if equipped). Turn adjusting bolt to tighten belt to ...

...as needed to adjust the belt tension. When the belt is replaced turn the bolt until the belt is tight. Remember to check the belt again after a few hundred miles. A new belt will stretch and

...tensioner to snap into position or damage could occur. Except for the 1.8L engine, adjust the belt tension and tighten the accessory mounting bolts. Serpentine drive belt routing - 1.8L engine ...

tensioner bolt on the side of the of the pulley, facing the front of the vehicle. 4 Remove the serpentine belt and then loosen the bolt on the alternator. With the alternator loose, move it forward so

...adjust. There probably won't be any adjustments. Serpentine Belts have be used for 25 or 26 years to my memory ,and have spring loaded tensioners to keep belt tight. So I quess your new to the car ...

...tensioner pulley back into position. 7 Look at all the pulleys and make sure the serpentine belt is properly seated on each one. Otherwise, release the belt tension and adjust the belt. 8 Connect the ...

...FAN BELT ON1998 Z3 bmw? how do i adjust fan belt? serpentine belts dont need adjusting they have a tensioner pulley that is spring loaded / you may need a new tensioner pulley or belt . hope that ...

adjust fan belt on toyota land cruiser 2008 79 series Hi there , there should be a adjuster on the alternator, unless it's a serpentine belt, if a serpentine belt then you will need a new tension bled

...tensioner should adjust and take the correct belt and tension it correctly. The reasons for belts coming off and worn / loose belt, wrong belt, tensioner not working, or incorrect belt alignment. ...