2002 Chrysler Town & Country "coil pack resistance" Questions

...coil (pack) Faulty oxygen sensor(s) Faulty fuel injector Burned exhaust valve Faulty catalytic converter(s) Running out of fuel Poor compression Defective computer If need additional details, just ...

...coil pack from the engine, using a wrench or ratchet and socket if necessary. If your coil pack is mounted on the back of the engine, raise the front of the vehicle and safely support it on two jack ...

coil pack cracks. ...(by cracks in the casing), the spark can actually jump to either ground, or another plug wire. ... An easy way to check if your coil is causing your check engine light is ...packs

...coil pack on your engine. It is malfunctioning. and, i recommend testing to make sure of thsi issue. Check for dirt, corrosion or damage on the terminals and repair as necessary. Measure coil primary ...

...coil pack on a 1998 f 150 4.2 measure resistence between companion outputs. they should be marked on the coill pack.12 ohm nominal. mesasure the resistence of the input terminal. 3 ohm nominal. i ...

...coil pack no spark out of number 2 coil pack the other three have spark You can test the pack. Not sure what the tolerances for this particular pack are, but the Primary should read in the .3-.9 ohm ...

...coil packs I need to know the resistance specs on borg warner's coil packs for ford 5.4 triton engine. Factory recommends 11k to 13k. Found autozones only have 6k. I don't know if this is feasible, ...

...coil pack, resistance should be 11,300-13,300 ohms. Use an ohmmeter to check secondary resistance as shown Check the primary resistance of the front coil pack by attaching an ohmmeter between the B+ ...

...coil pack, had spark after that but it stopped firing in 1-4 again.need to get it fixed for daughter to start school end of month.( dual coil pack) 2-3 firing fine If you have a volt/ohm meter, you ...

...coil pack Hi, first check fuse 19 inside the truck. If that's good, try disconnecting the capacitor from the wire--it may have burned up inside. If still no-go, check the resistance across the ...