2006 Cadillac SRX "remove plastic clips car" Questions

...remove the wooden trim around the cd player? It is retained by just clips. There are however very tight, and approximately 6 of them. Use a PLASTIC putty knife or similar tool, do not use anything ...

remove plastic headlight cover & pull pins (2) on light assembly whole light assembly will pull out then replace turn signal. Good luck. I have found a short cut for the change of turn signal bulb

...plastic housing and insert them back into their frame holes - or you will never get the housing back on. Once you have the housing loose disconnect the inside tail gate light wire to remove the whole ...

...plastic housing and insert them back into their frame holes - or you will never get the housing back on. Once you have the housing loose disconnect the inside tail gate light wire to remove the whole ...

...remove the plastic inner fender wells (the fasteners are a 2 piece plug/screw type fastener(inner and outter plug that is pushed in the hole that holds the inner fender wells in place. you can use a ...

...remove the center of the plastic clips, they will pop out, remove the rest of the remaining clip, once you have the plastic clips out, tail light will come off, no screw's holding tail light, just ...

...remove door panel on driver side by the door handle remove plastic trim atatched with veltcro start removing plastic clips with a clip remover some might break as some are meant to break when taken ...

...plastic clips. remove the clip by creafully prying with a screw driver and pulling them out. now slide the screw driver inbetween the fram and the trip panle. pry carfully and get you hand in there. ...

plastic piece just pops up. under the red reflector the is a screw. There is a "U" clip behind your window crank, remove this clip and the crank will pull straight out. (use a screw driver to open the

remove the plastic grill in front of it. The grill has plastic clips on the top side. The clips have a plastic center pin that must be pushed through. once the pins are out you can lever the clips up,