...crank sensor and ignition module. If you have a way to check RPM you should have about 200 cranking. If no rpm then crank sensor is bad and this could be tested if you know how with a digital meter. ...
...MOTOR YOU HAVE...THE CPS (CRANKSHAFT POSITION SENSOR) SHOULD BE MOUNTED UNDER THE LOWER TIMING BELT COVER BOLTED TO THE ENGINE BLOCK NEAR A GEAR WITH TEETH THAT THE SENSOR COUNTS AS THE CRANK ...
Question about Honda CR-V
...crank sensor. i want to say its behind the crank pulley Check the crank sensor connection and wires leading to it Let me ask this before you replaced the timeing it worked as far as the spark you had ...
2000 honda crv no spark and tach shows no rpms while cranking over? Sounds like you may have a defective Crankshaft position sensor. You might try checking the connector that goes to that sensor and ...
Question about Honda CR-V
sensor make the cat just shut down? And now the problem is getting worse, the car dies about every 1/4 mile. Same codes as before 02 is not the problem you stated there where cel on when the car died.
...are fine, it is likely one of the oxygen sensors; one is about $50 and the other is $200 (parts only). Use only Honda recommended parts, not BOSCH. where is de location sensor crank honda crv ...
Question about Honda CR-V
...sensor,ignition switch,fuel filter and just had my fuel pu My car has 160.000 miles--it shuts down randomly... was the fuel filter replaced with the pump? may also be an issue with the crank ...
Question about Honda CR-V
...crank angle sensor inside the distributor or ignition coil. Check for any codes. The crank angle sensor may set a code but not turn on the check engine light. If a code present for this sensor, the ...
...w/new ones,still won't start,I remove spark plugs & found they're wed w/gasoline,also install new crank & camshaft position sensors I remove the injectors manifold my son crank the engine while I ...
Question about Honda CR-V
crank they don't blink or dim. What the heck can it be ? Starter relay or a sensor or something. I even spun the engine with a ratchet to make sure it wasn't hydro locked. Help I'm ready to take it to
371 questions posted
Usually answered in minutes!
547 Questions
447 Questions
400 Questions
370 Questions
337 Questions