2003 Cadillac CTS "running awhile car stalls starting" Questions

...car has NEEDED an oil change for awhile, and it starts and runs but it will randomly die, and will crank but wont start back up. If you wait awhile it will eventually start back up after quite a bit ...

...car will start up and run for awhile "a mile or so up to ten miles " then stall and wont restart for a half hour to an hour later.The car has 234000 miles on it. Hello, I would start with a general ...

running awhile Lexus es300 codes- 1349,1354,1656. car starts ruff idling, then after running awhile starts bogging must push gas peddle down more to go again. acts like its going to stall when stopped

...awhile, my daughters car a 95 sunfire runs for awhile then shudders then stalls, it starts ok but as soon as you put it into drive it stalls, there is a new fuel filter, a mechanic told me that the ...

car started and seemed to run fine, within 3-5 min, the engine started to labor, stalled and would not start. Let cool for awhile and started ok, then same cycle. Petrol pump or filter, Say Please ...

mazda keep stalling i have a 2002 mazda 323 familia s/wagon, recently it started stalling while driving , start back after a couple minutes , will run for awhile , then it stall again , any idea what ...

...AWHILE THEN STALL OUT AND WILL NOT START THE CAR CAN SET FOR DAYS AND WILL START BUT WILL EVENUALLY STALL AGAIN Fuel filter, fuel pump, fuel pressure regulator, Idle air control valve, mass air flow ...

02 chevy silverado crankshaft sensor location my 94 chevy truck stalls even at highway speed ,it starts again but stalls after a few secs, finally it will run for awhile before it stalls again

...running awhile its starts to run fine (worse on cold days) help please!!! if you drive it before it runs awhile it runs very sluggish spit an sputter, an in some cases stall,but start right back up. ...

awhile then stalls The vehicle runs for awhile then stalls. Already changed injection pump. Mechanics/garages cannot figure it out. Manual says might be sticking metering value have no clue where that