...angle over 8% Trans fluid Temp input 68-248f Degrees not in fuel cut off, trans gear ratio indicates 2nd, 3rd, 4th gear delivered torque 32-150 ft lbs, the PCM detected a TCC slip value that was over ...
...angle air grinder with a medium grit pad to remove everything. once you've removed all the old gasket material use a shop towel or something along those lines to clean up the oil residue on the pan. ...
...Torque the nuts and bolts to 250 inch lbs. (28 Nm). Reconnect the wiring harness connectors to the oxygen sensor. Install the wiring harness grommet into the vehicle floor pan. Install the accessory ...
...torque is 95 - 270 Nm (70 - 200 ft. lbs.) . The TP indicated angle is 5-45 percent. The transmission fluid temperature is between 20°C (68°F) and 130°C (266°F) . The TCC is ...
...angle is greater than 12 percent. The input speed is greater than 1500 RPM. The engine torque is greater than 50 ft. lbs. (68 N.m). Conditions For Setting DTC DTC will set under the following ...
Question about Cars & Trucks
...torque on a bolt makes one realize that old fashioned ft/lbs is not accurate when tension bolts the tension is the stretching action of the bolt and that reading can be affected by the thread ...
182 questions posted
Usually answered in minutes!
242 Questions
234 Questions
173 Questions
175 Questions
176 Questions