2006 Subaru B9 Tribeca "dremel heat" Questions

...heat and a socket wrench.The easy out feels as if it may be too deep in the manifold From past experience I have taken a Dremel tool with a small drill bit carefully making two slices (one on each ...

...dremel, even an Easy Out Set. Any ideas on HOW to get it out so I can change my oil?? is it possible to get it to a garage they'd probably weld a bolt onto existing nut then heat the nut with blow ...

...heating the bearing and tapping on it around the edged to free it. Other option would be to use a dremel tool and cut the outer race in half. Once it separates remove the outer race, ball cage and ...

...heat in the passenger side floor board. I took a piece of 1.5" pvc pipe and notched it with the dremel tool, then took some HVAC Duct work metal tape and sealed the end of the pipe. I put the pipe so ...

...dremel tool, Hacksaw whatever you got and cut the bearing on both sides almost to the driveshaft. Then take a hammer and chisel and pop it real good. And call it a dirty ***********. And it fall off. ...

dremel. I have run out of options. the last mechanic said i may have to get another motor because no one gonna want to fool with it. Is there something else that can be done? remove crankshaft and get

...heat too the sorrounding area of the bolts should come apart easy then identify bolt sizes as sae (american like chevy) or metric (nova is same as toyota corrola), use correct 6point sockets, squirt ...

Dremel, but am lacking the necessary real estate to pound on the Irwins. Suggestions welcome, ideas accepted, and dirty looks thrown at that housing for free. Buy a couple of left hand drill bits &

...dont rember if the black box was rivited togeather or screwed togeather. if rivited, get a dremel tool with a grinder wheel, this will remove the rivites in good time. but the duct work was ...