1994 Jeep Grand Cherokee "egr valve" Questions

egr valve, there may be an attached "egr valve vacuum transducer"-a little device only there to increase or decrease the vacuum signal to egr valve, based on the amount of back-pressure in the exhaust

...EGR valve is the culprut im am out of options no one will touch it If no one has removed the EGR valve and inspected and cleaned it that could very well be your problem. If a pice of debris, ( chunk ...

EGR valve removed? I did not pass SMOG because there ewas little vacuum pressure to the egr. I took off the EGR and turned on the car to see if it would run different, and it did not have any problems

...EGR valve. Carbon will built up over time and it will block the movement of the EGR valve and the EGR air passage. Order a EGR base gasket before you start the job. The easy route is to order a new ...

...EGR valve. 3. Start vehicle 4. draw a vacuum on the line orally. a. the engine should die or run really bad. 5. Restart vehicle and repeat checking for same result. 6. If EGR valve is performing ...

...- Mass Air Flow Sensor: Damaged, Loose, or Faulty Mass Air Flow Sensor or Circuit. - EGR Valve: EGR Valve Sticking Open/Leaking. - Idle Air Control Valve: IAC Valve Sticking or Faulty. Good

...egr valve on the intake. It will have a vacuum line connected to it. Start the car when the engine is cold and let it warm up. As soon as it begins to die, disconnect the vacuum line from the egr. If ...

...1995 grand cheokee larado jeep 4wd where is the egr valve for shifting located on my jeep depends. if its the 4.0 6cyl it doesn't have an egr valve. if its the 8 cyl its in the right front of the ...

My egr valve was cleaned n put back on then 1 hour later my car ciesed up.is this because of the egr valve.on my 1997 buick leasaber Not likely.

EGR valve and see if it keeps running. If it does, replace the EGR valve. The reason the lights are all coming on and the gauges go to zero is because the engine dies and when it starts they return to