1999 Cadillac DeVille "ccm fuel problems" Questions

...CCM DetailsMIL DetailsTrouble Code Conditions: DTC P0117, P0118 and P0125 not set, Engine started; and the PCM detected the ECT sensor indicated more than 270ºF for 10 seconds. The PCM uses the ...

...Fuel Air Metering is the defintion of the code. What parts do I need to get to fix problem myself? Not sure where you got that definition for that code but this is what it is and means with possible ...

...lines.then i plug the fuel pump back in engine will start . i changed the ccm but that did not solve the problem.what is cheapest way to solve this problem. have you try changine the fuel pump ...

...FUEL TRIM:UPPER LIMIT,BCM-0100 COMMUNICATION PROBLEM WITH ECM,EPS-0082 ENGINE STATUS FAULTY SIGNAL,CCM-001 COMMUNICATION CONTROL MODULE;INTERNAL FAULT,DDM-E001 CONTROL MODULE COMMUNICATRION,INTERNAL ...

fuel door wouldn`t work either - a temporary solution for this was to take the switch out and connect the 2 wires that go to the release latch to a wire that I could put into the lighter plug. Now for

CCM) has detected that after a preset period of operation, the signal from the Oxygen Sensor (O2S) (Bank 1, Sensor 2) was higher than the maximum expected value. The O2S is the principal sensor in the

...CCM is in a plastic box and mine was undamaged, check yours. There is also a box under the seat which is a side impact detector for the side airbags (mine was disintegrated by salt and corrosion - ...

CCM) checks the fuel rail pressure (FRP) sensor for an acceptable fuel pressure. The test fails when the fuel pressure falls below or exceeds a minimum/maximum calibrated value for a calibrated period

...Fuel Rail Pressure Sensor Circuit High Input (FRP) The comprehensive component monitor (CCM) monitors the FRP sensor circuit to the PCM for high voltage. If voltage were to fall below a calibrated ...

...Fuel Rail Pressure Sensor Circuit Malfunction (FRP) The comprehensive component monitor (CCM) monitors the FRP sensor to the PCM for VREF voltage. The test fails when the VREF voltage from the PCM ...