1999 Lexus LX470 "series cam belt" Questions

...cam pulley lines (12o'clock) up with the centre of the 2 notches and the RH lines up (12 o'clock) with the single notch. On the crank one mark will be lined up with a single notch at about the 1 ...

Well yes and no, it is the same. The cam belt runs the cam and the cam runs the distributor, I believe on this engine. It (the cam) will have to be re timed to the main crankshaft during replacement.

...pump while I'm in there).Question is I see only one cam gear. Is other cam internal and driven of front cam by chain or something? Kia Rio Timing Belt Replacement 1 6L I4 16 Valve Auto Repair ...

how often must the cam belt be changed Does the BMW 318i have a cam belt? and if so when should it be changed? 1) No. 2) well it's not there so......you'll get it.

...cam). Even though you say the belt is good....make sure there isn't a series of teeth ripped of at the crankshaft sprocket (again, this would allow the belt to slip and not turn when the engine is ...

...series cam holder tool is use full for re-alineing cam marks camshaft marks facing each other and crank line up with raised mark on engine block,it is then a case of putting every thing back inthe ...

...series, engines, 1.0, and more. is SOHC, single overhead cam. all have a cam belt so in a nut shell, remove the valve cover remove belt cover. (lots of steps, im not typing them all out) RTM loosen ...

...cam gear if it will not align . there is one tooth of play in the intake gear and when you have locked the rear intake cams and have marked the safe position on the crank you can install the timing ...

...belt? I've changed a number of timing belts on dual overhead cam engines and haven't needed an allignment holder for the cams and engine pully. Why is it necessary for this engine, and where is the ...

...series cam belt .. by Technozen of ...soy espa?ol porfavor quiero saber timing marks de MG ROVER 25 petrol 1795cc engen .... Hi, Have a Land Rover Freelander1999 petrol serie K, that dont start, ... ...