1991 Lexus LS 400 "crank sensor ls400" Questions

1991 lexus ls400 doesn't accelerate Clean, inspect and, or, Replace your crank sensor or, crank sensor wiring A loose crank sensor bracket or, a start relay has caused this before

...ls400 1991 stopped firing up. It turns over but no go. Everything else seems to be working fine. Is there a commom problem that causes this? check/change the crank sensor and check your ignition ...

my lexus ls400 cranks starts and cuts right off,I replaced crank sensor and fuel pump.what may be the next thing? factory immobiliser

...belt, tune up, coolant temp sensor, new radiator cap, ignition coils. was also leaking from the front driver side of car but it stopped. not sure what it was or from where. I would try a crank ...

...crank sensor &both ignition coils. i'm wondering if i need to change the timing belt. Yeah, it's time for the timing belt. The crank and the cams sensors have to be on the the exact timing marks. ...

sensor. or the crank position sensor. it is the only signal that the computer can not duplicate. and when that sensor goes out or stops working it also disables the fuel supply and the ignition system

crank sensor.reset the computer by disconnecting the battery for 10 minutes. started the car and no change.after i found out my timing was a litte off i decided to change the timing belt & cleaned the

...crank.i have to turn it over 3-5 timesbefore it starts. it is getting fire and checked the plugs and are wet with gas. put in new plugs and cranks on 2-4 tries, but is still too much gas when running ...

...LS400 will crank and will drive but will not accelerate at times then it will do somewhat fine on the highway not going over 65mph, in the city it will not pick up and it cuts off when at a complete ...

...LS400 cranks but will not stars CHECK FOR SPARK AND FUEL.IF ALL IS GOOD A BAD COLD START VALVE WILL CAUSE COLD ENGINE START UP PROBLEMS COLD START VALVE DOES SAME JOB AS ENGINE COOLANT ...