1991 Lexus LS 400 "crank sensor" Questions

...read " No RPM signal while cranking. Lexus LS 400 1993 Clean, inspect and, or, Replace your crank sensor or, crank sensor wiring A loose crank sensor bracket or, a start relay has caused this ...

1991 lexus ls400 doesn't accelerate Clean, inspect and, or, Replace your crank sensor or, crank sensor wiring A loose crank sensor bracket or, a start relay has caused this before

1991lezus alldashlightsstayon willnotstart checkenginelighthasbeenstayingon CRANK POSTION SENSOR OR CAMSHAFT SENSOR ,IF THERE BAD IT WILL NOT CRANK AT AL

crank sensor.reset the computer by disconnecting the battery for 10 minutes. started the car and no change.after i found out my timing was a litte off i decided to change the timing belt & cleaned the

sensor. or the crank position sensor. it is the only signal that the computer can not duplicate. and when that sensor goes out or stops working it also disables the fuel supply and the ignition system

...belt, tune up, coolant temp sensor, new radiator cap, ignition coils. was also leaking from the front driver side of car but it stopped. not sure what it was or from where. I would try a crank ...

...crank sensor not working when hot,trace this and pour cold water on it(dont do this if it is not by crank pulley as water isnt good for modules etc) and retry.2/sparkplugs worn,but usually they would ...

...crank sensor. The harness connector needs to be checked for a 5v reference signal and the ground side needs to be checked for a good ground. This test is to rule out the computer as being the issue. ...

...crank sensor &both ignition coils. i'm wondering if i need to change the timing belt. Yeah, it's time for the timing belt. The crank and the cams sensors have to be on the the exact timing marks. ...

my lexus ls400 cranks starts and cuts right off,I replaced crank sensor and fuel pump.what may be the next thing? factory immobiliser