...remove the jumper wire and switch the key off before clearing the codes. Here are some common Lexus vehicles 1990-1995 codes: Code 12 and Code 13 Rpm signal circuit fault Code 14 Igniter signal ...
...ignition switch or bad starter wire from the starter switch, or the PNP is not adjusted correctly: Here are instructions on how to remove and replace the PNP, but read over it to understand how to ...
Question about Cars & Trucks
...REMOVE THE IGNITION COILS TO GET TO PLUGS,HERE'S A COUPLE OF LINKS TO SHOW YOU HOW TO REMOVE SPARK ...
...GS300 won't start. When you turn the key to the start position nothing happens. I checked my ignition switch and have juice when in the start position. I checked my starter but I'm not getting juice ...
...Remove the key from the ignition cylinder within ten seconds. It will be the only key still programmed to work Add Duplicate Key: 1. Simultaneously depress and release brake and accelerator pedals 1 ...
ignition switch in the LOCK position, disconnect the negative battery terminal. If equipped with an air bag system, wait at least 90 seconds or longer before performing any other work. Remove the rear
ignition switch OFF, disconnect the battery cables, negative terminal first. Allow 90 seconds to elapse before performing any other work. Raise and safely support the vehicle. If necessary, remove the
394 questions posted
Usually answered in minutes!
531 Questions
242 Questions
176 Questions
155 Questions
93 Questions