what caused engine to lock up and what's the price to repair If equipped with cambelt check to see if it has snapped. If it is cambelt new valves would be needed head gasket and head bolts then ...
Question about Ford Cars & Trucks
Valve clearances for a 2.5 turbo diesel ford courier Pe 2000. intake 0.20mm exaust 0.38mm adjusted with engine cold. with 1 and 6 fully open - adjust valves 4 [inlet] and 7 [exhaust] valves 2 and 3 ...
...valve rocker arm adjustment diagram. first get engine in number 1 firing position, adjust exhaust valves 1 - 3 - 4 - 8 adjust intake valves 1 - 2 - 5 -7 now turn engine another ...
...Valve Lash ADJUSTMENT 1.6L Engines NOTE: Measure valve clearance with the engine cold. Before servicing the vehicle, refer to the precautions in the beginning of this section. Remove the valve cover. ...
Question about Cars & Trucks
08 Civic EX, valves became noisy at60K, valves quiet after warmup. They will probably still be noisy after I adjust them. Would the cause be excessive wear on the valves stem ends and rockers? If ...
Adjustment is possible at idle but it is best to use valve clips to keep the oil from squirting all over the place. After cranking the engine over by hand, where 1/4 turn after the Intake valve closes
Question about Lexus RX 330
when the valves are adjusted on the de-compression stroke can they be re-adjusted or is the head now faulty? The valves were adjusted on the decompression, stroke can the be re-adjusted to the right ...
...valve clearance: If the clearance is not within the specified range, adjust the clearance by loosening the lock nut on the rocker arm and turning the adjustment screw. Tighten the lock nut when the ...
Question about Cars & Trucks
what is the clearance between the rocker arm and the valve spring in a GM 2.2L motor gape clearance between rocker arm and the valve spring? Also the proper procedure for setting the valves . there is
valve adjustment How ot set valve adjustment on 2001 Hyundai Tiburon 2.0 DOHC (Mitsubishi engine) Specs on clearances tiburon uses hydrolic lash adjusters there are no valve lash adjusting If you ...
297 questions posted
Usually answered in minutes!
430 Questions
56 Questions
20 Questions
6 Questions
1 Questions