1993 Lexus Es 300 "unplugging fan clutch check engine" Questions

...fan switch on the power steering pump or by unplugging the temp sensor(below the alternator). Rev the engine to 2500rpm and the fan should spin harder. If this does not happen, have the filter and ...

...clutch with the radiator fan relay if the fans kick on then replace the fan relay if the fans do not kick on you have either a faulty temp sensor on the fan or the fan itself is bad. if the fan is ...

...fan clutch you need a special tool(fan clutch removal tool), autozone will let you borrow for free with a security deposit. Make sure engine is cold. Remove negative battery terminal1. Drain all ...

clutch to engage. All fuses checks good, FIRST IS CHECK ENGINE LIGHT ON....YOU SHOULD BE ABLE TO UNPLUG THE ECT... ELECTRONIC COOLING TEMP SENSOR.....A TWO WIRE SENSOR THAT TELLS THE COMPUTER THE TEMP

...fan clutch or the relay any answers anyone Fan clutch failure is common on these........and very costly to replace. With the engine cold, engine off, reach in and turn the fan, it should turn with ...

...fan clutch connected to a pulley on the fan belt to draw air through the radiator, these fan clutches wear out and become slow not cooling down the radiator to there full potential. It also affects ...

...fan blade clutch on my 2004 Envoy because when turning on the heat or a/c truck would shut off. Now that fall is approaching, i need to get to the root of the problem. Is it the Fan Blade Clutch or ...

...fan clutch is a known problem with our I6 engine. While your fan may slow down as it get warmer, it's still engaging a little. Here's what I'd do first, check the connection on right side of fan ...

...fan clutch. These have been a big problem for gm. The good news is that the new one from gm is redesigned and you should also have your local gm dealer check your vehicle as there is an updated ...

...Clutch fan? It is probably bad, there is a spin test you can do by yourself, if it spins more than 3 times it's bad, that is full revolutions. Also start engine, turn on A/C to max, if fan does not ...