1992 Lexus Ls 400 "fan bracket" Questions

...fan pulley bracket. need to take off the timming belt to get to the water pump. also need to remove the distributor covers on bothe sides. 2 boolts that hold the a/c compressor to the fan pulley ...

...fan bracket assembly bearing for 1995 Lexus Ls400 anywhere, not available through bearing agents...what's with this? its like that,have to go to the dealership. which is gonna cost a arm and an leg ...

...fan clutch support bracket because the shaft was bent. After repairs the engine would not start w/ nothing but a clicking @ the starter. replaced starter. same problem. I removed the upper camshaft ...

...fan bracket pully and drove it about 25 miles and it shut off so I pulled over and tried to start it and it starts and shuts off. It will do the same thing every time. It will start and the rpms goes ...

fan bracket and line. Inspect the seal and install a new seal if necessary. Disconnect the return hose from the cooling fan and shroud. Separate the return hose from the fan shroud and position aside.

...fan relay. It lives under the right headlamp below the plastic bracket that holds the headlamp assembly. You can do this one of two ways. Remove the bumper fascia, headlamps, and bracket that runs ...

...FAN - REMOVAL). Remove the wiring harness clip from front mount. Remove the coolant line clamp bolt (COOLANT LINE BRACKET). Remove the upper nut from the front mount (FRONT RUBBER MOUNT UPPER NUT). ...

...fan bracket and line. Using the appropriate special tool, install a new O-ring on the power steering pressure hose fitting. Separate the return hose from the fan shroud and position aside. Remove the ...

...fan shroud (8146) assembly as described. Remove radiator upper bracket retaining bolts and remove bracket. Lift radiator from vehicle. Installation Position the radiator into the vehicle. Install ...

...fan and shroud to the radiator and install the assembly. Attach the radiator bolts and brackets. Tighten the radiator bracket bolts to 7 ft. lbs. (10 Nm). Connect the coolant reservoir overflow hose. ...