cam shaft censor and ECM, and coil. distibuter cap looks bad has some white dust inside and contacts burnt. could it be that? If you did not replace the CRANK sensor on the back side of the motor this
Question about Jeep Grand Cherokee
...cam shaft positioning no signal. . tested all circuit. changed cam shaft positioning sensor twice.still cranks did start once ran for 5 min. changed the sensor again. no luck. help please. keith ...
...cam shaft sensor and it did not make a difference and he put the old one back in. I'M LOST. HELP I Found that the outboard PCM cover screw was shorting out the circuit board. Short story long: I have ...
...shaft sensor keep moving the harness as you go if the engine stops then you may have a wire that losing connection all it takes on this vehicle is a erract sigal from crank and cam sensor to pcm to ...
...engine? change cam sensor. check wiring. cam sensor can make the pcm think the crank is bad. you may have bad wiring. that year the wiring goes over the exhaust manifold it could be metaled ...
...Cam shaft sensor code, I replaced the cam sensor 2 times, changed the plugs and wires, Changed the PCM, also fixed and replaced vaccum lines, Replaced wires that was damaged from the harness to the ...
Question about Jeep Grand Cherokee
...and the engine still turns over ? run fault codes and check for cam/crank position sensor. Check that the cam shaft is turning ( broken timing belt/chain) check that the immobiliser is
...is talking about the bank 1 or something is wrong in the camshaft, what i need to do, The cam shaft sensor is faulty. replace this sensor. the light will go off when this replacement is
...Cam shaft sensor, and Cam shaft synchronizer. Gave the car a full tune up with replacing the spark plugs and wires. Changed the transmission fluid, and checked all the fuses in the fuse box. The car ...
cam shaft sensor its located on top of engine normally on the timing belt side, hope this helps ( rate me thanks ) i changed the water pump in a 96 maxima and now it will turn over but won't start
2,181 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions