1996 Audi A4 "1 8" Questions

...1/8 turn before the wheels respond. while on the highway the steering wheel is off center slightly to the left. I would say have a look at your Track rod ends or have them inspected plus have the ...

...8 1. SAE 5W-30 / 5W-40, VW 502.00 - all temperatures. 2. SAE 10W-30 / 10W-40, VW 502.00 - all temperatures. 3. SAE 5W-50, VW 501.01 - all temperatures. 4. SAE 10W-50 / 10W-60, VW 501.01 - all ...

...1 is detecting that the catalyst is not working as efficiently as it should be. (Too much free oxygen in the exhaust downsream of the converter) This can be caused by leaks in the exhaust system ...

...Wire Off at SPARK PLUG END Stick a Screwdriver in it to get good Contact Start Engine And HOLD Screwdriver Close to GROUND SURFACE 1/8 th Inch and see if there is a SPARK if there IS Suspect ...

...1) Open trunk 2) Remove small round plastic access panel with a flat tip screw driver by prying open 3) Remove flat tip screw holding tail light assembly 4) Remove tail light assembly by pulling ...

...8 seconds, the car would shake violently upon acceleration at about 1/3 throttle. I cleaned the Mass Air Flow Sensor. This helped but did not solve all my problems. I then replaced the Mass Air Flor ...

1 plug and check to see if it is fowled. This will show you what one looks like http://www.ehow.com/video_2326832_identify-bad-spark-plug.html and this video http://www.youtube.com/watch?v=C6A1keWQAeE

...1. Switch off all electrical equipment. 2. Remove ignition key. 3. Insert two radio release tools T10057 into slots on radio (bottom front side) until they engage. 4. Pointed ends of grips must face ...

what is engine firing order for 4.2 liter Audi on my auto data it sayes it is 1 / 5 / 4 / 8 / 6 / 3 / 7 / 2 hope this is a help as i dont no the year or modle

1/8" I.D. tubing. Look at the rubber door seal along the top edge of the door - see how it's kind of a channel shape? Press the tubing into the groove, and cut it off flush with the end of the groove.