...Install a new water pump gasket and the water pump onto the cylinder block. Tighten the retaining bolts to 12-15 ft. lbs. (16-20 Nm). Reinstall the timing belt and the timing belt covers as outlined ...
Question about Mercury Mystique
...Install a new water pump gasket following the instructions of the new pump manufacturer. 10P osition the new water pump in place over the housing and install the mounting bolts by hand. Tighten the ...
Question about GMC Cars & Trucks
...Install the NEW spark plugs. Tighten: Tighten the spark plugs for a USED cylinder head to 15 [n-m] (11 lb ft). Tighten the spark plugs for the initial installation of a NEW cylinder head to 30 [n-m] ...
...Install a new cylinder head gasket onto the cylinder head assembly. Apply sealant to the gasket and do not reuse the old cylinder head gasket. 3. Install the cylinder head bolts. Starting at top ...
...Install the cylinder heads. Use new gaskets and tighten the bolts, in sequence, as follows:Step 1: Bolts 1-8 to 20 ft. lbs. (27 Nm)Step 2: Bolts 1-10 verify torque without looseningStep 3: Bolts 9-12 ...
Question about Mercury Cars & Trucks
...install, noting following: a. Clean cylinder head intake manifold, valve cover and cylinder head gasket surfaces. Ensure flatness of cylinder head and cylinder block gasket surfaces meets ...
Question about Cadillac Cars & Trucks
...Install the cylinder head with a new gasket. Lubricate the bolts with engine oil prior to installation. Torque the M11 bolts in sequence as follows: Step 1: 30 ft. lbs. (40 Nm), plus an additional 70 ...
...bolts, clean the mating surface, install new gasket, and reattach the valve cover with the bolts. You may need to remove the following spark plug wires vacuum lines air cleaner assembly oil filler ...
...@ 114mph now 12:90's @ 107mph. Head gaskets are new as well. Motor does not smoke or burn oil or foul plugs. Can you help me find an answer to this problem? MORE THAN LIKELY BROKEN RING ON A ...
new valve cover gasket (6584) on cylinder head and install retaining bolts. Note location of ignition wire routing clip stud bolts. Tighten retaining bolts to 9-12 Nm (7-9 lb-ft). Install upper intake
332 questions posted
Usually answered in minutes!
405 Questions
198 Questions
165 Questions
131 Questions
94 Questions