2001 Chrysler PT Cruiser "causing battery drain" Questions

...drain on a battery will shorten it's life. If you have a wire shorted out somewhere on your vehicle, it could be draining the battery ever so slightly, start by looking for a dead short in the

2001 pt cruiser limited won't crank wind chill -35 deg..... went to start, cranked a couple of times, drained battery trying, jumped battery (cables on correct), cranked twice then nothing. Replaced ...

...door locks 2001 PT Cruiser, door locks lock and unlock by themselves causing the battery to drain overnight make sure than the car has not any aftermarket alarm installed if it does have it remove ...

was starting fine, then would not fire, or start Try this turn the ignition on and then off slowly three times and then finally on again. Look at the mileometer it may report Pxxxx error code(s) for ...

...causing the dead battery. You will need to get it to a shop that can trace wires and find the ones that need to be replaced. Some times it can be the wire right at the alternator where the wires are ...

2006 pt cruiser, cooling fan motor stays on after car is shut off, drains battery. car is not overheating though. check the fluid in the radiator, and replace the thermostat the way it is positioned ...

...causing this condition: * Bad connection on the POS (+ RED) battery lead * Blown main fuse (from the POS battery lead) * Drivebelt incorrectly tensioned * Defective battery * Faulty alternator * ...

battery slowly goes dead on my 2001 pt cruiser You will need to take it to the shop find the drain. Something running that has constant power most generally its the radio but they have ways of finding

...causing the battery to drain obviously -- Try disconnecting the negative terminal on the battery and connecting a test light , clamp one end to the battery terminal and the other to the cable ...with ...

drain the battery. Bad door or trunk switches for the dome lights can cause the lights to stay on. You can test for ignition off draw with the right testers to see if it's within specs. You could also