Question about Chrysler Concorde
bottom against the top edge of Special Tool 8186 (3). Failure to properly perform the resetting procedure may cause tensioner jamming. NOTE: Inspect the tensioner O-ring (2) for nicks or cuts and make
...Remove the pump module and gasket from the tank. Drain the remainder of fuel from the reservoir before servicing the pump module. To install: NOTE: The fuel pump module and tank have alignment marks. ...
...tools. Turn the control arm over in the arbor press, then position the arm so that it is supported by the receiver tool MB-990799 as shown. Position the new bushing into the control arm so it is ...
tools are required to remove pitman arm from steering box on 1983 oldsmobile cutlass supreme? You need a ,large adjustable wrench,a 9/16 wrench, a hammer, and a pitman arm puller. It is a special tool
...Remove the nut on the bottom of the upper ball joint using a wrench. Separate the ball joint using the ball joint separator tool. Insert the tool between the spindle and the upper control arm and hit ...
...bottom Ball joint Depressurize the hydraulic system. Jack the front and put on jack stands (both left and right side). Remove wheels. Slacken and unscrew the ball joint nut partially. Release ball ...
...arm. Then center Installer, Special Tool 6908-4 on the bottom of the ball jointCarefully align all pieces. Then press the ball joint into the lower control arm until it is completely seated against ...
Question about Lincoln Cars & Trucks
...remove the pitman arm on a 96 Lincoln town car. Any suggestions? There are several ways to attempt this job, depending on the tools available to you. The best way is to use a puller. This tool is ...
...Remove the block of wood supporting the upper control arm. Install a new cotter pin through the ball joint stud.Install the grease fitting on the bottom of the ball joint. Use a c-clamp to push the ...
Remove the linkage from the pitman arm at the bottom of the box. Use a large hammer to break the linkage free from the arm, don't hit the threads. You will see 3 or 4 large bolts going threw the frame
378 questions posted
Usually answered in minutes!
439 Questions
405 Questions
313 Questions
291 Questions
268 Questions