...left of the left cam... the other is to the right of the right cam.... and the marks for the crankshaft pulley are at the 9 and 3 position on a clock. the 2.3 litre appears to be a single cam ...
...in certain spot as well as timming mark on belt driven cam gear to cover this cam gear is a 3:1 ratio (3 turns of cam gear = 1 turn of cams) i am putting the timing belt un time but my car dont turn ...
Question about Isuzu Trooper
...cam and 24 valves Timing Belt Removal 1. Disconnect battery ground cable. 2. Remove air cleaner assembly. 3. Remove radiator upper fan shroud from radiator. 4. Move drive belt tensioner to loose side ...
...3 litre jeep. and jeep wont start woos the fly wheel and ring for sensor have to go on in a special spot. please help if u no and how could or wood u line it up ???????? if its a 4JX1 diesel, yes it ...
...cam? If it's the belt, there should be 3 lines on the belt. Put the belt on the cams and turn them until all 3 of them line up with the timing marks on the cams. If it is a timing issue, you need a ...
...3 oclock, 6 oclock, 12 oclock? the timing marks for the cams are on the rear timing cover (behind the cam sprockets). They are very hard to see, especially the rear cam. Align the cam sprocket marks ...
...Cam pulley 3 - HP Oil pump pulley 4 - Tensioner pulley 6 Cylinder petrol: Align crank(C) timing notch mark (1) to oil pump mark. Align cam pulley(L+R) marks(3) to cylinder head marks The cam belt has ...
...cam at 12 o clock crank at 6 o clock marks in rear timming cover twin cam cams marks face each other 3 & 9 o clock crank at about 6 o clock mark in cover all marks are visible on gears and ...
...cam must be aligned. From here I cannot tell you where thes marks are but they are usually at 12:00 or 3:00 plus when you get near the alignment point the cams will feel almost like they are ...
...3 TRIES. ( CAMS WANT TO MOVE DURING PROCESS.) WHEN TIMING IS JUST RIGHT , IT WILL RUN. MAKE SURE BOTH CAM SROCKET ARROWS ARE POINTING UP. THERE IS A TIMING MARK IN THE VALLEY OF THE EXHAUST CAM ...
279 questions posted
Usually answered in minutes!
480 Questions
463 Questions
423 Questions
323 Questions
317 Questions