2002 Isuzu Rodeo "remove blower motor fan switch" Questions

...Remove the blower motor(3 screws on the bottom of the unit under the passenger side dash) and connect jumper leads from the battery directly to the blower motor to see that it operates. The blower ...

blower for the heat working in any settings. I already replaced the fan motor and am not sure if the resistor is bad. I need to know how to check the resistor and possibly how to remove control module

...blower is right in front of the glove box. Remove the glove box, unplug and test for voltage first on the blue/white wire and make sure it not just a bad fan switch, they go bad more than the blowers ...

...to top pin on motor? above. got 12vdc to bottom pin of motor if yes, the switch is failing remove blower resist and check all paths for 0 ohms. if not ,zero its bad and for sure that thermfuse

...to check or a relay? Or could it be a wire problem? I am hoping it is something simple. Thank you for your time and help. You need to check the "blower motor resistor" first to see if it is

remove the blower and hotwire it to the battery to see if it works. If not, replace the blower. Then run continuity tests on the swoitch and replace switch if bad. If you have questions, please let me

...remove Blower control switch? http://howtobyme.blogspot.in/2012/02/how-to-remove-blower-control-switch-on.html---------Where is blower motor relay located ? ...

...remove the blower motor from the vehicle. If the blower motor fan (also called a 'squirrel cage') must be replaced, use the following procedure: NOTE Do not hammer on the motor to remove or install ...

...panel insulator.Remove the blower motor resistor.1Disconnect the electrical connector.2Remove the screws.3Remove the blower motor resistor.INSTALLATION To install, reverse the removal

...Remove blower resistor screws and blower resistor. To install, reverse removal procedure Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using ...