2005 Suzuki Forenza "high idle" Questions

...engine It may be an idle sensor or you need to adjust your idle setting. It may be getting to much fuel also. Does it do this all the time? Sometimes, the map sensor can cause it to idle high as

idle being too high. You will never get a IAC code for this condition, What this code is prabably about is you may have a bad TP sensor Small vacuum leak. Too high fuel pressure Some other sensor that

...idle and stops flashing but remains on when driving?? please help Check your oil----is it very high? Put a piece of cardboard under your car overnight, see if you have any leaks externally. If not, ...

RPM's very high when driving and stay there I have and 05 Suzuki Forenza that has been high idling and the RPM's are at 3 or 3500K and stay there while while im driving. The dealership has reset the ...

IDLE SPEED is fixed in the PCM< , its no CARB now since 1988, so, a wasted talking them. if the pressure is low, what is your oil, 10w-30 , or 10w-40? try this oil or try a new oil sender some come

High Purge Flow Fault. No warranty coverage? - Likely a sticking purge valve, possibly accompanied by some strange cold idle conditions. - Possible fuel tank pressure sender with an 'in range' failure

idle up real high then shut off lots of causes for that. which engine the 2.0L? (8 used world wide) takes me 1 to 10 tests to find most failures. first is to scan it, to see if there serious, problems

...idle (very high it will be) thick cold oil, like 50 psi.
hot idle low, 20 psi. is typical.
then race engine to 2500 rpm for a few secs. must not drop. but rise.
if the pressure are low, the ...

...high air flow from the MAF. the ECU sees that and is a grand contraction, and sets a DTC. not the A/B comments. , im not sure what A/B correlation means.? is your car with Automatic, and some have ...

...the cooling system. Thermostat new, and not put in wrong, wax side to input side,RTM, bleed hole high (jiggle pin,etc) I use an IR pyro gun $15 to check ALL rad tubes top and bottom so see if one ...