1996 Jeep Grand Cherokee "replace fan switch 96" Questions

...96 Mercury Sable with the standard 3.0L engine. Not the HO engine. The two electric cooling fans for the radiator does not run. I have checked the fuse and that is not the problem. I am figuring I ...

...fan switch did i miss something? I think there are two fan switches on the 99 but I don't recall for sure. At some point during the B5 chassis run (96-01) they went from two two-wire switches to a ...

...console. I'm sure this the cause, but can't afford to replace one thing after another. What is the most affordable test I could do to troubleshoot the rear air? fan switch failure,no fan no ...

...ave. heater fan will not shut off unless i disconnect the battery cables. can't seem to find a fuse for it. any ideas? It's not a fuse problem. The controller switch is not working and needs

...switch work but fan speeds do not. I was told it was a possible resistor problem. where do i look? It is not a resistor you blower motor is going out it needs to be replaced. When fan speeds don't ...

...switch but cold air only not coming out but not hot either. nothing overheats yet fan not turning on.. Then it's not a relay you need to check but the series resistor pack inside blower housing. This ...

...fan switch. The ac is turning on the fan because, when ac is on the car would run warmer, so the ac switch is also connected to the fan. Are you saying that the ac kicks on when iddling or that's the ...

...fan goes on, a leak of preston comes out the cap of the tank, so i change the cap,same problem, i switch radiator from a used one...same result...only thing i can see will be to change the ...

...switch Recently had a camaro with the same issue.What I found was the fan itself causing the issue. It was creating so much resistance at the fan motor that the only time it would function is if it ...

...fan broke, just replace it. Try hooking the wires directly to the battery, make sure it spins the right direction, if not, reverse the wires but make sure the fan is on the right way, you may need to ...