...servo actuates the 2nd gear band,and the front servo actuates the 4th gear,or O.D. band.The rubber lip seals on the servo pistons are soft and pliable when new,but with hot and cold cycles,and years ...
Question about Cars & Trucks
...servo on the diff. Gear oil is going to pour out unless you drain it first. Soory last pic 5 Once removed installation is the opposite. Just be sure not to turn anything inside the casing once you ...
...gear slipping in od sounds like the 2/4 band or servo. servo applies the band in second and forth if the bands burnt up or old it wont hold, and if the o rings in the servo are cut or damaged it will ...
...servo until the valve it closes shuts and then we remove one gear...i can now use the car but far less performance than we expect.how does the servomechanism works? The role of servo is toadjust the ...
...gear cage is thinner and the 13 vine pump is weaker and prone to failure more then the 10 vain. The best improvement to the 4L60E is to swap out the servo's with a corvette servo's. The servo's will ...
...gear ratio error.The fix is to drill out the servo bores and sleeve them. If you get an overhaul, which I believe any dealership you take it to would advise you to do, make sure they do that whether ...
Question about Pontiac Cars & Trucks
...Servo Seals Rolled, cut or damaged 4T65-E Slipping or No Fourth Gear Slipping or No Fourth Gear Checks Cause DEFINITION: A large engine RPM increase is noted in fourth gear, Drive range, with little ...
...gear signal is present for more than 5 sec. ? Transfer shaft speed is greater than 900 rpm ? Fluid temperature is above 60°C ? PCM receives an "OFF" signal from K/D servo s/w Check item ? ? ? ? ? ...
...gear your problem is in the 2-4 servo assy. area. this the round external cover on the right frount side of transmission.remove cover and remove servo assy.Check the teflon sealing rings for nicks or ...
...gear indicates a problem in the torque converter clutch area ( automatic transmission) or clutch hydraulic or cable system If hydraulic would be in the master cylinder -replace it or cable breaking ...
409 questions posted
Usually answered in minutes!
480 Questions
463 Questions
423 Questions
323 Questions
317 Questions