2002 Chrysler PT Cruiser "3 lower intake" Questions

...Please provide solution. Check on intake silicon gaskets, upper and lower. About $18 at autozone check the  #3 coil. code p0303 says misfire on #3 cylinder.this causes your vehicle rough

...3. Lift the air filter out of the air box. 4. Disconnect the PCV hose from the lower air box. 5. The lower air box is removed by just tugging straight up on it. It will pop out as it's held in place ...

...3. Lift the air filter out of the air box. 4. Disconnect the PCV hose from the lower air box. 5. The lower air box is removed by just tugging straight up on it. It will pop out as it's held in place ...

lower timing belt cover fasteners and remove cover CAUTION: When aligning crankshaft and camshaft timing marks always rotate engine from crankshaft. Camshaft should not be rotated after timing belt is

...lower intake manifold. Tighten the bolts in sequence and in 3 steps, as follows: Step 1: 26 inch lbs. (3 Nm). Step 2: 106 inch lbs. (12 Nm). Step 3: 133 inch. lbs. (15 Nm). Install or connect the ...

...lower intake manifold bolts. from front of engine tighten 2 bolt back left side, then 3rd bolt back right side, then 3 bolt back left side, then 2nd bolt back right side, then back bolt left side, ...

...hoses and linkages. Replace the lower gaskets and torque the manifold in a radiating sequence in this order.stages to tighten stage 1 - 59 inch pounds stage 2 - 66 inch poundsstage 3 - 90 ...

into the intake ports of the heads that can cause hydro-locking. once the lower intake manifold is removed you will see the sensor right on top of the engine block about 3/4 the way back. good luck...

...3- The cylinder heads and the lower intake manifold are installed together 4- 10-12 ft. lbs. +60-65 degrees 5- Step 1: 72 ft. lbs. 6- Step 1: bolts 11-22 19 ft. lbs. 7- Step 1: 20 ft. lbs. 8- Step 1: ...

...lower intake manifold bolts prior to installation. Install the bolts and tighten in sequence and in 3 steps as follows: First step to 26 inch lbs. (3 Nm). Second step to 106 inch lbs. (12 Nm). Final ...