2005 Jeep Liberty "crank sensor" Questions

...crank sensor and cam sensor, the voltage to both sensors are 5.0V, however no spark is showed on spark plug, If I remove any sensor connector cam-or -crank shaft sensor a weak spark is showed ...

crank sensor. I have power going to one side of wires on crank sensor but nothing to the other side, so jeep won't start anyone got any suggestions please? On the crank sensor you should have a 5 volt

...crank position sensor or its connection is probably at fault. The engine needs the signal that the crank postion sensor provides to inject fuel and supply spark at the correct

...back of the engine or on the transmission bellhousing. Your Cam Sensor is at the top and your Crank Sensor is near the bottom. Hope this gives you some direction. Thanks for using FixYa! Sincerely, ...

crank sensor and now Im getting PO725 code.Would it be the camsensor that is giving me this code? no, that code is for crank sensor: Engine RPM input - circuit malfunction Possible Causes: Wiring, CKP

...crank sensor out of a 2003 jeep liberty but I can't get the new one to go back in? make sure to buy a crank sensor from the dealer. it will be a little more but it will actualy fit and will last ...

...crank sensor is used only for misfire detection and NOT spark timing (this varies with the vehicle), the vehicle should start and run with MIL (Malfunction indicator lamp) illumination. Also, some ...

...good battery and connections. Steering wheel wont lock but key will turn. crank turned one time but turned backwards after it turned Could be problem with cam shaft sensors and crank shaft

...crank or cam sensor,if I had to guess it would be crank first but next time it dies try restarting right away without shutting key off first and let the engine crank for about 30-40 sec if it don;t ...

...crank sensor code. Replacement of this sensor is fairly common. I have heard of a chafing concern which occurs near the cam sensor that shorts the power supply to one or both sensors. I recommend ...