...crank angle sensor shown in the image, then it will be located on the bell-housing towards the top of the bell-housing and usually on the drivers side. Dis-connect the faulty crank angle sensor and ...
...crank angle sensor is located at the front of the engine down near the bottom pulley that sits on the end of the crank. You should see (under the grime :) ) a small sensor with a pigtail leading to ...
...the crank angle sensor on 1999 4.0l Jeep grand cherokee laredo replaced and now have a loud ticking noise coming from engine. Help the sensor assembly has to be set just right to be in time with ...
94 jeep won't start fuel pump working. Injectors not firing. Could it be a fuse ? relay ? Check connector at crank angle sensor (CAS). If you still not getting spark then replace CAS.
...crank angle sensor sensor near the transmission inspection plate. CAS can intermittent and fail with no warning. I turn down a job because the "other guy": used a tire iron pry open the inspect the ...
...still does it.whats up? Have some one check your crank angle sensor or replace it. This has caused a lot of intermittent problems on this year jeep vehicle. It will lead to the a lose of ECU ...
...replacing the filter may help with a fuel pressure problem though ultimatly you may have to replace the pump as well. To know for sure you will have to monitor the fuel pressure. Another possible ...
pump crank angle sensor coil wires plugs cap rotor turns over no spark to plugs ? Take 2 screws out of PCM and replace with shorter ones Check the distributor for loose connections inside, on the coil
...Crank Angle Sensor (CKP) and Cam Angle Sensor (CMP) signals to check quality and sync. Loose timing chains or broken flex plates can change the sync signal to the Powertrain Control Module (PCM) and ...
3,525 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions